What should my crossover be set at?

11
Tre Collins asked a question: What should my crossover be set at?
Asked By: Tre Collins
Date created: Wed, Jul 7, 2021 5:49 AM
Date updated: Fri, Oct 7, 2022 12:38 PM

Content

Top best answers to the question «What should my crossover be set at»

The most common crossover frequency recommended (and the THX standard) is 80 Hz. On-wall or Tiny 'satellite' speakers: 150-200 Hz. Small center, surround, bookshelf: 100-120 Hz. Mid-size center, surround, bookshelf: 80-100 Hz.

The most common crossover frequency recommended (and the THX standard) is 80 Hz. On-wall or Tiny 'satellite' speakers: 150-200 Hz. Small center, surround, bookshelf: 100-120 Hz.

9 other answers

Look at the back of your subwoofer, then set the low-pass crossover at least 10Hz higher than your main speakers’ range. This range is the starting point when configuring your crossover. If your center speaker can produce 80Hz to 120Hz, then you want your low-pass crossover to be anywhere close to 90Hz.

Most AVRs have two controls that are sometimes called crossovers. One is a true crossover that reassigns the bass that would otherwise go to the RF, LF, C, and surrounds to the subwoofer . Audyssey, THX, and most experts tend to recommend that this crossover be set to 80 Hz.

If you know your speaker’s frequency range, set the crossover point roughly 10 Hz above the lowest frequency your speakers can handle cleanly The most common crossover frequency recommended (and the THX standard) is 80 Hz. The numbers below highlight general guidelines for speaker/subwoofer crossover frequencies

If your speakers have a gentle downward slope at the crossover frequency (like a 10db/octave slope), follow the same convention and set the crossover frequency at 80 Hz. If the speakers have a more shallow slope, choose a crossover frequency that sounds good to you.

Set the crossover point 10 Hz higher than this range for the best result (or go with the recommended 80 Hz). Listen for a smooth transition between your subwoofer and the rest of the speakers ensuring that the sound is crisp.

If the coaxial speakers to use a passive crossover network, the crossovers should be set the same as the component speakers mentioned above. Recommended Starting Points: Front Component Speakers - High-Pass Filter = 80 Hz (12 db or 24 db Slope)

Your crossover should be set no lower than the lowest manufacturers’ rated speaker response at +/- 3dB. You can find this in your users’ manual or on the manufacturers’ website. If you can’t find this specification anywhere, you can guesstimate based on the diameter of the largest driver in your speaker.

A THX Select or Ultra2 system is specifically designed to have the bass management set at 80Hz. While you are free to alter the crossover frequency of a THX system, you will not be utilizing the system as it was intended to be heard. In addition, THX processing and DSP assumes (and sometimes initiates) an 80Hz crossover setting for the LFE.

Where Should I Set My Subwoofer Crossover? I just upgraded to a bigger subwoofer, a JBL ES250P rated at 400 watts RMS and 700 watts peak power. The sub specs say it can play down to 25 Hz, which is very low, and the sub has a crossover adjustment that goes from 50 Hz to 150 Hz. My HSU Research speakers are rated down to 60 Hz.

Your Answer