Why does my go kart keep stopping?

11
Angeline Glover asked a question: Why does my go kart keep stopping?
Asked By: Angeline Glover
Date created: Fri, Jun 4, 2021 3:21 AM
Date updated: Wed, Sep 21, 2022 1:59 PM

Content

Top best answers to the question «Why does my go kart keep stopping»

A bad spark plug or loose plug wire will prevent the engine from running. A clogged or wet air filter will shut the engine down. Check the stop switch, a failed switch will prevent the engine from running. A tripped oil guard sensor (9hp Vanguard equipped units only)

10 other answers

Go-karts utilize either a centrifugal clutch or torque-converter and depending on your setup, the proper solution will vary. This article will cover the top 5 reasons why your go-kart takes off when started or moves while idling and will provide you the best way to solve the problem based on your individual setup.

Air filters in the engines of go-karts can cause issues if they get wet or clogged. An air filter can become clogged with water or dirt particles. When the air filter is clogged, the go-kart’s engine cannot draw in enough air to circulate throughout. This causes the engine to stop altogether.

Sprockets on a go-kart must be in alignment to work properly. If one of the sprockets is misaligned with the other it can lead to the teeth on the chain not completely setting in the sprocket. If this misalignment is severe it can cause the chain to jump off the sprockets completely and the entire chain will fall off your go-kart. How To Fix It:

In this video I show you guys some of the reasons why your go kart or mini bike chain could be falling off. SUBSCRIBE FOR MORE WEEKLY GO KART & ENGINE VIDEOS!!

The brass color screw located below on the side of the carburetor, next to the choke lever is for the fuel and air mixture. Start by turning this screw (clockwise) until it stops. Don't turn it in tight, just until it stops. Next, turn the screw out two full turns (counter-clockwise).

Having a fuel-powered go kart engine requires adequate maintenance to run efficiently. Stalling problems occur in two circumstances, either problems with the ignition or problems related to fuel injection, or even a combination of both.

Water mixed with gasoline will cause a go kart engine to start and then stop. If there are any signs of water beading around the bottom of your gas tank, you will have to drain all the gasoline from your tank and carburetor and re-fill it with pure gasoline. Also check your fuel cap or tank for leaks to ensure that this does not happen again.

Adjust the alignment of the large sprocket to the small sprocket using a metal ruler placed flat on the small sprocket…the leading edge of the ruler. I assume the engine is bolted tight tothe frame. If this doesn't work, the large sprocket could b...

Re: how can i stop my son's go kart from eating up belts From what I can see from your pictures, your drive pulley (small) is out of alignment with the driven pulley (large) this will cause it to chew up belts quickly.

Check gas and oil: If the engine has water in the gasoline, it will start, run for a few seconds, then as soon as the water hits the carburetor the engine will die. You can look in the bottom of the gas tank and see water "beading" around if it's present. If the gas tank and carburetor do contain water it has be removed completely. 2.

Your Answer